DE2 24P
tighten one screw through the front of the rack and into the top hole in the rails. c) Adjust the
rail lengths to fit, and position the rear rail location pegs in the corresponding rear rack holes. d)
Insert and tighten one screw through the back of the rack and into the back of the rails.
If your rack is a threaded universal 19-inch cabinet: a) Use the T20 Torx driver to remove the rail
3
location pegs from the front and rear of the rails. b) Use the supplied wrench to insert two pins
into each end of the rails, in the same location where the location pegs were removed. c)
Position the front of the rails inside the cabinet, with the rail flange inside of the cabinet flange,
and the rail label facing the inside of the cabinet. The pins should be fully located within the rack
holes. d) Insert and tighten one screw through the front of the rack and into the top hole in the
rails. e) Adjust the rail lengths to fit, and locate the rear pins inside the corresponding rear rack
128
Oracle ZFS Storage Appliance Installation Guide • January 2014 E48491–02