Table of Contents
Advertisement
Mktg Part Number
7103791
X1109A-Z
X4242A
7101674
7100477
7100488
X2129A
X5562A-Z
PCIe Riser Configuration
The three risers are labeled Riser 1, Riser 2, and Riser 3. Though similar, the risers are not
interchangeable. Riser 1 installs at the left rear of the chassis, Riser 2 at the center rear, and Riser
3 at the right rear of the chassis. Each riser can accommodate two PCIe cards:
Riser 1 contains slots 1 and 4
■
Riser 2 contains slots 2 and 5
■
Riser 3 contains slots 3 and 6
■
PCIe Options
The following table describes the supported PCIe configuration options for the ZS3-2
controller. Slots 1 and 2 are reserved for internal- and external HBAs, as shown in the following
table. When adding PCIe cards, populate from higher order slots (6) first toward lower order
slots. Note: Any empty PCIe slots must have a filler panel installed.
Slot
Mfg Part Number
1
7047852
2
7067091
3
7067091
3
7070195
3
371-4325-02
Chapter 1 • Introduction
Description
4-port (4x4 SAS-2) 6Gb/s external HBA
2-port 10GbE SFP+ NIC
2-port Infiniband CX2 HCA
2-port 16Gb FC/FCoE Universal HBA
4-port 1Gb Copper Ethernet UTP
2-port 10Gb Ethernet Copper Base-T
XCVR 850NM, 1/10GPS, SFP, short reach
10GbE/1GbE SFP+ Transceiver, long reach
Description
8-port 6Gb/s SAS-2 internal
HBA
4-port (4x4 SAS-2) 6Gb/s
external HBA
4-port (4x4 SAS-2) 6Gb/s
external HBA
4-port 1GbE copper NIC
UTP
2-port 8Gb FC HBA
Max
Note
1
Base configuration
2
Base configuration
2
Second 4x4-port SAS-2 external HBA
3
Optional recommended front-end
4
Optional FC target or initiator (backup)
ZS3-2
23
Advertisement
Table of Contents
