Table of Contents
Advertisement
- Use your right hand to support the CMA and use your left thumb to push in (toward the left)
on the connector D latching bracket release tab labeled PUSH, and pull the latching bracket out
of the left slide-rail and put it aside.
To disconnect connector C, perform the following steps:
5
- Place your left arm under the CMA to support it.
- Use your right thumb to push in (toward the right) on the connector C release tab labeled
PUSH, and pull connector C out of the right slide-rail.
To disconnect connector B, perform the following steps:
6
- Place your right arm under the CMA to support it and grasp the rear end of connector B with
your right hand.
- Use your left thumb to pull the connector B release lever to the left away from the right
slide-rail and use your right hand to pull the connector out of the slide-rail.
To disconnect connector A, perform the following steps:
7
- Place your left arm under the CMA to support it and grasp the rear end of connector A with
your left hand.
- Use your right thumb to pull the connector A release lever to the right away from the left
slide-rail, and use your left hand to pull the connector out of the slide-rail.
Remove the CMA from the rack and place it on a flat surface.
8
Go to the front of the rack and push the storage controller back into the rack.
9
ZS3-4 Controllers
ZS3-4 Controller Installation Tasks
This section provides steps for installing the Oracle ZFS Storage ZS3-4 controller into a rack
using the rail assembly in the rack mount kit. Note that if your rack mount kit shipped with
installation instructions, use those instructions instead.
Observe the following cautions:
Always load equipment into a rack from the bottom up so that it will not become top-heavy
■
and tip over. Deploy the anti-tip bar to the prevent the rack from tipping during equipment
installation.
Chapter 2 • Installation
ZS3-4 Controllers
93
Advertisement
Table of Contents
