Table of Contents
Advertisement
ZS3-2 Controllers
To prepare the CMA's connector D for installation, remove the tape that secures the slide-rail
11
latching bracket to connector D and ensure that the latching bracket is properly aligned with
connector D (frames 1 and 2).
While holding the slide-rail latching bracket in place, insert connector D and its associated
12
slide-rail latching bracket into the left slide-rail until connector D locks into place with an
audible click (frames 1 and 2). When inserting connector D into the slide-rail, the preferred and
easier method is to install connector D and the latching bracket as one assembly into the
slide-rail.
Gently tug on the left side of the CMA's rear slide bar to verify that connector D is properly
13
seated.
Gently tug on the four CMA connection points to ensure that the CMA connectors are fully
14
seated before you allow the CMA to hang by its own weight.
90
Oracle ZFS Storage Appliance Installation Guide • January 2014 E48491–02
Advertisement
Table of Contents
