Table of Contents
Advertisement
Performing Initial Configuration with the CLI
Login using the password you provided during Installation:
caji console login: root
Password:
Last login: Sun Oct 19 02:55:31 on console
To setup your system, you will be taken through a series of steps; as the setup
process advances to each step, the help message for that step will be
displayed.
Press any key to begin initial configuration ...
In this example, the existing settings are checked (which were obtained from the DHCP server),
and accepted by typing done. To customize them at this point, enter each context (datalinks,
devices and interfaces) and type help to see available actions for that context. See the Network
section for additional documentation. Pay careful attention to the Clustering Considerations
for Networking section if you will configure clustering.
aksh: starting configuration with "net" ...
Configure Networking. Configure the appliance network interfaces. The first
network interface has been configured for you, using the settings you provided
at the serial console.
Subcommands that are valid in this context:
datalinks
devices
interfaces
help [topic]
show
abort
done
caji:maintenance system setup net> devices show
Devices:
DEVICE UP
MAC
igb0 true
0:14:4f:8d:59:aa
igb1 false
0:14:4f:8d:59:ab
igb2 false
0:14:4f:8d:59:ac
igb3 false
0:14:4f:8d:59:ad
caji:maintenance system setup net> datalinks show
Datalinks:
Chapter 4 • Powering On and Configuring the System
=> Manage datalinks
=> Manage devices
=> Manage interfaces
=> Get context-sensitive help. If [topic] is specified,
it must be one of "builtins", "commands", "general",
"help" or "script".
=> Show information pertinent to the current context
=> Abort this task (potentially resulting in a
misconfigured system)
=> Finish operating on "net"
SPEED
1000 Mbit/s
0 Mbit/s
0 Mbit/s
0 Mbit/s
Initial
167
Advertisement
Table of Contents
