Table of Contents
Advertisement
Support the CMA and do not allow it to hang under its own weight until it is secured at all four
8
attachment points.
Insert the CMA's connector B into the front slot on the right slide-rail until it locks into place with
9
an audible click (frames 1 and 2). The connector B tab (1) goes into the slide-rail front slot (2).
Gently tug on the right side of the front slide bar to verify that connector B is properly seated.
To install the CMA's connector C into the right slide-rail, perform the following steps:
10
- Align connector C with the slide-rail so that the locking spring (1) is positioned inside (server
side) of the right slide-rail (frame 1).
- Insert connector C into the right side-rail until it locks into place with an audible click (frames
2 and 3).
- Gently tug on the right side of the CMA's rear slide bar to verify that connector C is properly
seated.
Chapter 2 • Installation
ZS3-2 Controllers
89
Advertisement
Table of Contents
