Oce Arizona 550 GT User Manual page 217

Maintenance Station Switches
There are 3 switches inside of the maintenance station . They can be operated in any order.
For example, you can press the second switch to raise the carriage to remove debris from
the underside of the carriage even when a purge is not required.
Switch 1 to purge ink
1.
Switch 2 to raise carriage
2.
Switch 3 to activate suction pump
3.
Illustration
[163] Maintenance Station Switches
How To Perform Maintenance
Verify that the ink temperature is at least 40° Centigrade (104° Fahrenheit) before you
1.
begin printhead maintenance.
Slide the maintenance station cover out from under the carriage.
2.
Press and release switch 1 to initiate a purge. The carriage will lower to its purge height
3.
(4mm above the table surface). Watch the ink as it falls from the heads. After a few seconds
most of the ink stops dripping and you can then raise the carriage.
Press switch 2 to raise the carriage to its maximum height.
4.
Attention:
Be careful not to snag the coiled suction-head hose when removing the suction-head from
the holder.
Printhead Maintenance
Chapter 11 - Printer Maintenance 217