Oce Arizona 550 GT User Manual page 93

Remove any old foam tape that is no longer required in the new configuration.
4.
Clean the area of the overlay sheet where the new foam tape is to be applied with isopropyl
5.
alcohol.
Measure and add tape (part # 3010106701: gray silicone foam tape) in the desired locations
6.
to create zones. When you create a zone we recommend that active vacuum holes are a
minimum of 15 mm from the outside edges of the media. This optimizes the sealing effect
between the media and the table.
[67] Join the tape with no gaps
Note:
Make sure there are no gaps at any of the places where tapes join at a right angle. Also
make sure the gray custom tape does not overlap the black perimeter tape.
Carefully lift the overlay back to its original position and rest the edge on the Control
7.
side of the table in the vertical orientation.
Note:
Ensure that the alignment holes in the overlay are on the same side as the two alignment
pins on the flatbed.
Lower the upper end of the overlay slowly as you slide your hand inward to support the
8.
center to avoid bending until it is completely level with the flatbed.
Line up the two holes in the overlay with the two registration pins and square the overlay
9.
to the flatbed.
How to Create Custom Vacuum Zones
Chapter 5 - How to Operate the Océ Arizona 550 GT 93