Oce Arizona 550 GT User Manual page 74

How to Power the Printer On and Off
During the boot-up procedure, the printer software is automatically started. The software
4.
displays a splash screen followed by a screen that requests you to raise and then lower the
carriage guard.
Lift the carriage guard slightly and then replace it. At the control station click on Continue
5.
to finish the startup procedure.
[56] AC Power Switch
The splash screen will show initialization messages and then the Print Job Control module
6.
screen appears. The initialization is complete when the top left panel of the display shows
"Ready". Your printer is now ready for use.
Attention:
After powering the printer On, leave it running continuously, even when at idle. Failure
to leave the printer powered on may result in ink draining out of the ink reservoirs. It
may also result in damage to the printheads. Leave the printer powered On at all times,
unless service to electrical components is required.
Note:
The printer is designed to be left powered ON at all times as only minimal power is
consumed when the printer is idle.
74 Chapter 5 - How to Operate the Océ Arizona 550 GT