Oce Arizona 550 GT User Manual page 91

How to Create Custom Vacuum Zones
[64] Metric Vacuum Zones
How to Set Up Custom Zones
Attention:
When you remove the aluminum overlay to create custom zones, be careful that you
don't bend or warp it. Always have a second person to assist you when you handle the
overlay. Wear clean gloves to avoid the deposit of oil and dirt on the overlay surface.
The aluminum overlay sheet lays on the printer table surface and is positioned using two
registration pins that are bonded to the table. The circular hole and the oval slot in the
overlay sheet fit over the registration pins and hold the overlay from moving on the table
surface. This section explains how to handle the overlay when you remove it from the
table to create custom vacuum zones.
Attention:
Be careful that you don't hit the registration pins when you remove or replace the overlay.
If these pins are dislodged, there is a replacement kit available or you can re-glue them
with epoxy.
Chapter 5 - How to Operate the Océ Arizona 550 GT 91