Oce Arizona 550 GT User Manual page 116

How to Load Media
C: Thread the Media
Select the Load icon from the Roll Media Manager.
1.
If you are going to print with "Print Side In", click the icon in the Roll Media manager
2.
("Print Side Out" is the default so you do not need to select it unless you have recently
used Print Side In). Note that the icon toggles from one choice to the other when you
click it.
Note:
For Print Side Out, the media unrolls from the bottom the supply shaft as shown in green
on the left below.
For Print Side In, the media unrolls from the top of the supply shaft as shown in red on
the right below. This allows you to print on the "back" side of the media.
[74] Media Path Choices
Wait for the gantry to move part way across the table.
3.
Continually press on the right foot pedal, as required, to gradually advance the media for
4.
the next two steps.
116 Chapter 6 - How to Operate the Roll Media Option