Chapter 4 - Oce Arizona 550 GT User Manual

Print Parameters
10) Printer Interface Module Tabs
These tabs allow you to switch between different functional modules of the printer. Click
on a tab to display the screen associated with each of the modules available.
11) Software Version Number and Image Upload Progress
Displays the version of the currently installed printer software.
The image upload progress panel indicates the name of a job that is currently uploading
to the printer. This panel only displays information while an image is transferred from
the ProductionHouse computer.
Displays information about the print job that is currently
selected:
Mode - Print quality mode: Select Production, Quality,
or Fine Art mode in ProductionHouse. When Quality
mode is set, this field will have a pull-down box that allows
you to select Quality-Matte or Quality-Density (or
Quality-Layered if the White Ink option is installed).
Quality-Matte provides a matte finish to the entire image.
This is helpful on some media such as FomeCore,
GatorPlast or Styrene as a glossy image tends to have a
matte line at the end of each swath with these media.
Quality-Matte resolves this issue. (Note: This mode is
not available on 5xx printers).
Quality-Density provides more density for backlit media.
This is most useful when you print on roll media, since
Overprint is only possible on flatbed jobs. Also for flatbed
media that may warp or move slightly from the heat of
the lamps, the Density mode will reduce that because it
is done in one pass.
Direction - Bidirectional and Forward or Reverse unidi-
rectional printing
Overprints - If the Overprint count is set to greater than
0 (zero), the printer will re-print the image again on the
same piece of media.
Copies - use the mouse to increase or decrease.
Type - Print Method - Flatbed or Roll.
Media - Media that was selected in ProductionHouse.
Notes - Appears only if a note was specified for the job.
Notes are entered in ONYX ProductionHouse.
Chapter 4 - How to Navigate the User Interface
Print Job Control Module
59