Oce Arizona 550 GT User Manual page 119

Tape the media onto the core. The media should have a clean straight edge prior to taping.
9.
First tape the center of the media to the core, and then tape both ends of the media.
[78] Tape Media to the Take-up Roll Core
Note:
Ensure that the media is flat along the core. If the media is not flat it can create an uneven
roll that affects the motion of the media past the printheads and therefore the quality of
the image.
Use the supplied ruler to check that the take-up roll is centered within 1mm (or 5mm if
10.
you use the edge detection sensor).
D: Initialize Roll Media To Prepare For Printing
Select the "Initialize" icon from the Roll Media Manager to properly tension the media
1.
and to prepare for printing.
E: Select Existing Or Create New Media Parameters
From the Roll Media Manager select the media to be printed on or create a new set of
1.
media parameters for the media loaded. Refer to the Roll Media Manager section for
details.
Chapter 6 - How to Operate the Roll Media Option
How to Load Media
119