Installation; Led Indications - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
terminal, the blade may not be able to detect the difference between
straight cable and cross-cable automatically. If auto-crossover is not
functioning, use straight cable for that terminal connection.
Table 4-54 CD-RTB Maximum Upgrade Capacities
maximum capacities for the ESIU blades when they are upgraded.
Table 4-54 CD-RTB Maximum Upgrade Capacities
19" Chassis
with CPU
1
The Router blade can also be used to provide power over category 5
network cables. This eliminates installing separate power adapters
for each IP telephone and it allows for centralized power backup.
6.2.2

Installation

To install the CD-RTB:
1. Plug the CD-RTB blade into any universal slot.
2. Refer to the Univerge SV8100 Programming Manual for
required programming.
6.2.3

LED Indications

LED indications for the CD-RTB are indicated in
LED Indications. Each LED is listed with its associated function and
LED and Operational status. Refer to
page 4-103
LED Function
CN2, CN3 LAN
LINK/ACT Operation
Status
CN2, CN3 LAN Speed
10/100 Status
19" Chassis
without CPU
2
for the location of the LEDs on the blade.
Table 4-55 CD-RTB LED Indications
LED Status
Green On
Green
Flashing
Green Off
Orange On
Orange Off
provides the
19" Chassis Networked
x4 Chassis
8
Table 4-55 CD-RTB
Figure 4-36 CD-RTB Blade on
Operation
Comments
Status
Link Established Individually for
Ports 1~8
Communicating Individually for
Data Ports 1~8
Not Activated Individually for
Ports 1~8
100Mbps Individually for
Ports 1~8
10Mbps Individually for
Ports 1~8
Issue 4.1
50
4 - 105