NEC Univerge SV8100 System Hardware Manual page 45

UNIVERGE SV8100
Table 2-4 Maximum System Capacities – Blades
each blade that can be installed in a system.
This is determined by the maximum blade configuration allowed. When installing
single line sets, DISA, or tie lines, CPU circuits must be allocated for DTMF receivers.
To install single line sets with CO/PBX line access, or when installing immediate-start
tie lines, CPU circuits must be allocated for dial tone detection.
Hardware
Number of Slot(s) for Interface
Package
Common Control Blades:
CD-CP00
PZ-32IPLA
(32-port VoIP Daughter Board)
PZ-64IPLA
(64-port VoIP Daughter Board)
PZ-128IPLA
(128-port VoIP Daughter Board)
PZ-32IPLB
(32-port VoIP Daughter Board)
PZ-64IPLB
(64-port VoIP Daughter Board)
PZ-128IPLB
(128-port VoIP Daughter Board)
PZ-ME50
(Memory Expansion Board)
PZ-VM21
(Voice Mail Daughter)
Station Blades:
CD-4DIOPB
(4 DID/OPX)
System Hardware Manual
Table 2-4 Maximum System Capacities – Blades
9.5"
Chassis
Chassis
with CPU
3 Slots 5 Slots
1
1
1
1
1
1
1
1
1
2
shows the maximum number for
19"
19"
Chassis
Chassis
without
CPU
6 Slots 23 Slots
1 0
1 0
1 0
1 0
1 0
1 0
1 0
1 0
1 0
5 6
Issue 4.1
19"
x4
Comments
0 –
1 This unit provides 32
VOIP Gateway
channels
1 This unit provides 64
VOIP Gateway
channels
1 This unit provides 128
VOIP Gateway
channels
1 This unit provides 32
VOIP Gateway
channels
1 This unit provides 64
VOIP Gateway
channels
1 This unit provides 128
VOIP Gateway
channels
0 –
0 Does include modem
23 When installed as an
OPX blade
2 - 9