Installation; Switch Settings; Led Indications - NEC Univerge SV8100 System Hardware Manual

Issue 4.1
Link 10/100
(LED 1)
LINK 1000
(LED2)
DUPLEX
(LED3)
ACT
(LED4)
4 - 40
3.5.2

Installation

To install a PZ-32IPLB/PZ-64IPLB/PZ-128IPLB on the CD-CP00 :
1. With the system power off, remove the CD-CP00.
2. Install the IPLA Daughter board onto the CD-CP00 blade.
3. Insert the CD-CP00 into slot 1 in the Controlling Chassis or.
Refer to
.
3-41
4. Connect the IPLB Daughter board to the CD-RTB or to an
external switching hub using an ethernet cable.
5. Refer to the Univerge SV8100 Programming Manual for
detailed programming instructions.
3.5.3

Switch Settings

These daughter boards do not have any switches that need to be set
and do not require any hardware setting.
3.5.4

LED Indications

LED indications for the PZ-32IPLB, PZ-64IPLB and PZ-128IPLB
Daughter Boards are indicated in
LED Indications. Each LED is listed with its associated function and
LED and Operational status. Refer to
with Daughter Boards Installed on page 4-17
LEDs on the blades.
Table 4-17 IPLB Daughter Board LED Indications
LED Function
10Base-T/100Base-TX link
speed indicator
1000Base-T link speed
indicator
Duplex Status
Link activity or data
transmission and reception
Do not remove or install the CD-CP00 with the
power on.
Figure 3-45 19" Controlling Chassis – Guides Slot 1 on page
for more details.
LED Status
On Red
On Red
On Yellow
On Green
UNIVERGE SV8100
Table 4-17 IPLB Daughter Board
Figure 4-4 CD-CP00 Blade
for the location of the
Operation Status
100Base-TX link up
1000Base-T link up
Full duplex operation
Link up completed
Installing the SV8100 Blades