Option 2 - NEC Univerge SV8100 System Hardware Manual

Issue 4.1
3 - 30
12. Refer to
continue installation of the chassis or
Extension or Trunk Blade on page 4-4
2.5.2

Option 2

1. Use the template shown in
Guide (9.5" Chassis) on page 3-25
drilling.
2. Mark and drill four holes.
3. Install four screws into the four drilled holes (refer to
3-34 Install Screws (Option 2) on page
2.8 Installing the 9.5" Chassis on page 3-54
Figure 3-28 Wall Mount Spacing
Plywood should first be installed on the wall
where the chassis will be positioned. This
allows secure anchoring of the screws which
support the weight of the chassis.
UNIVERGE SV8100
to
2.2 Installing an
for installation of blades.
for required spacing before
Figure
3-31).
Installing the SV8100 Chassis