Installation; Connectors - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
5.2.2

Installation

To install the PZ-4COTE
1. Four plastic spacers are included with the COIDB. Install the
plastic spacers on the CD-4COTA or CD-LTA blade. Make sure
to attach the spacers so that they extend out on the side of the
daughter board which has the CN1 connector.
2. Position the PZ-4COTE CN1 connector over the CN4
connector on the CD-4COTA or CD-LTA. Press the blades
together, ensuring the plastic spacers lock in place.
3. Install the PZ-4COTE blade (refer to
PZ-4COTE Daughter Board on page 4-71
5.2.3

Connectors

Table 4-37 PZ-4COTE RJ-61 Cable Connector Pin-Outs on page
4-73 shows the pin-outs for the RJ-61 connector. Refer to
4-25 Installing the PZ-4COTE Daughter Board on page 4-71
illustration showing the location of the connectors on the PZ-4COTE
blades.
Table 4-37 PZ-4COTE RJ-61 Cable Connector Pin-Outs
The CN2 connector is polarity sensitive (tip-to-tip, ring-to-ring).
:
RJ-61 Cable Connector
CN2, Trunks – Connecting to COIU Blade
Pin No.
1
2
3
4
5
6
7
8
Issue 4.1
Figure 4-25 Installing the
).
Figure
for an
Connection
Circuit 8 – Tip
Circuit 7 – Tip
Circuit 6 – Tip
Circuit 5 – Ring
Circuit 5 – Tip
Circuit 6 – Ring
Circuit 7 – Ring
Circuit 8 – Ring
4 - 73