Switch Settings; Remote Pc Programming Access; Pz-32Ipla/Pz-64Ipla/Pz-128Ipla (Voice Over Ip Daughter Boards) - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
3.4
System Hardware Manual
3.3.3

Switch Settings

This daughter board does not have any switch that needs to be set
and does not require any hardware setting.
3.3.4

Remote PC Programming access

The VM21 card provides a V34 modem for PC Programming
connection.
The modem is accessed via a DIL trunk or Auto Attendant routing to
the modem access number as defined in CM11-15-14.
Using a Windows Dial Up Connection it is recommended that the
following Properties settings are used:
Under the Security Tab, select Advanced radio button and set the
following under 'Settings'
Under the General Tab, select configure and uncheck 'Enable Modem
Compression'
Once connection to the system is established select IP-Dialup from
the PC Programming connection menu and enter username and
password.
PZ-32IPLA/PZ-64IPLA/PZ-128IPLA (Voice over IP Daughter
Set Data encryption to 'Optional'
Check all boxes relating to CHAP
Uncheck PAP & SPAP selections
Ensure 'the box related to Windows logon is unchecked
Issue 4.1
4 - 33