Cabling - NEC Univerge SV8100 System Hardware Manual

Issue 4.1
S
S 5
YSTEM
ECTION
5.1
2 - 16
R
EQUIREMENTS AND

Cabling

This section provides cabling requirements and specifications for various
equipment used in the SV8100 system.
Figure 2-4 Connecting the DLC Using Twisted 2-Pair Cable
chassis connected with each of the multiline terminals and single line
telephones by a separate twisted 1-pair cable or 2-pair cable (only for Multiline
Terminals).
DLC
Figure 2-4 Connecting the DLC Using Twisted 2-Pair Cable
Refer to the following tables for cabling requirements and specifications.
Table 2-12 DT300 Series Loop Resistance and Cable Length
Table 2-13 DT700 Series Loop Resistance and Cable Length
term
Table 2-14 D
Length
Table 2-15 Cable Connection Between the Analog Port and the Single Line
Equipment
Table 2-16 Cabling Requirements
Table 2-12 DT300 Series Loop Resistance and Cable Length
Terminal or Adapter
DTL-2E-1 (BK) TEL
DTL-6DE-1 (BK) TEL
DTL-8LD-1 (BK) TEL
DTL-8LD-1 (WH) TEL
DTL-12BT-1 (BK) TEL
DTL-12PA-1 (BK) TEL
DTL-12D-1 (BK) TEL
DTL-12D-1 (WH) TEL
S
PECIFICATIONS
Twisted 2-Pair Cable
term
Series i or D IP Terminal Loop Resistance and Cable
By Twisted 1-Pair
Cable (without
AC Adapter)
24 AWG
1,969 ft (600m) 6,562 ft (2000m)
1,969 ft (600m) 6,562 ft (2000m)
1,969 ft (600m) 6,562 ft (2000m)
1,969 ft (600m) 6,562 ft (2000m)
1,969 ft (600m) 6,562 ft (2000m)
1,969 ft (600m) 6,562 ft (2000m)
UNIVERGE SV8100
is a diagram of the
RJ-11
Multiline Terminal
By Twisted 1-Pair
Cable (with AC
Adapter)
24 AWG
SV8100 System Specifications