Displaying And Maintaining Lldp; Lldp Configuration Examples; Basic Lldp Configuration Example - 3Com 4500 PWR 26-Port Configuration Manual

Follow these steps to configure LLDP trapping:
To do...
Enter system view
Enter Ethernet interface view
Enable LLDP trap sending
Quit to system view
Set the interval to send LLDP
traps

Displaying and Maintaining LLDP

To do...
Display the global LLDP
information or the information
contained in the LLDP TLVs to
be sent through a port
Display the information
contained in the LLDP TLVs
sent from neighboring devices
Display LLDP statistics
Display LLDP status of a port
Display types of advertisable
optional LLDP TLVs

LLDP Configuration Examples

Basic LLDP Configuration Example

Network requirements
As shown in Figure
Switch B are connected to Ethernet 1/0/1 and Ethernet 1/0/2 of Switch A.
Enable LLDP on the ports of Switch A and Switch B to monitor the link between Switch A and Switch B
and the link between Switch A and the MED device on the NMS.
system-view
interface interface-type
interface-number
lldp notification remote-change
enable
quit
lldp timer notification-interval
interval
display lldp local-information
[ global | interface interface-type
interface-number ]
display lldp neighbor-information
[ interface interface-type
interface-number ] [ brief ]
display lldp statistics [ global |
interface interface-type
interface-number ]
display lldp status [ interface
interface-type interface-number ]
display lldp tlv-config [ interface
interface-type interface-number ]
72-4, the NMS and Switch A are located in the same Ethernet. An MED device and
Use the command...
Use the command...
72-12
Remarks
—
Required
Required
Disabled by default
—
Optional
5 seconds by default
Remarks
Available in any view
Available in any view
Available in any view
Available in any view
Available in any view