Displaying And Debugging User Interface - 3Com 400 Family Configuration Manual

Configuring Redirection
send command The following command can be used for sending messages
between user interfaces.
Perform the following configuration in User View.
Table 27 Configuring to Send Messages Between Different User Interfaces
Operation
Configuring to send messages between
different user interfaces.
auto-execute command The following command is used to automatically run
a command after you log in. After a command is configured to be run
automatically, it will be automatically executed when you log in again.
This command is usually used to automatically execute the
the terminal, which will connect the user to a designated device automatically.
Perform the following configuration in User Interface View.
Table 28 Configuring to Automatically Run the Command
Operation
Configure to automatically run
the command
Configure not to automatically
run the command
Note the following points:
■
■
Telnet 10.110.100.1 after the user logs in through VTY0 automatically.
[4500-ui-vty0]auto-execute command telnet 10.110.100.1
When a user logs on through VTY 0, the system will run
automatically.
Displaying and After the above configuration, use the
Debugging User the running of the user interface configuration, and to verify the effect of the
Interface configuration.
Use the
Table 29 Displaying and Debugging User Interface
Operation
Clear a specified user interface
After executing this command, the user interface can no longer be used to
carry out the routine configurations for the local system. Use this command
with caution.
Make sure that you will be able to log in the system in another way and cancel
the configuration, before you use the
save the configuration.
command in User View to clear a specified user interface.
free
User Interface Configuration
Command
send { all | number | type number }
Command
auto-execute command text
undo auto-execute command
auto-execute command
command in any view to display
display
Command
free user-interface [ type ] number
37
command on
telnet
command and
10.110.100.1
telnet