Source
T
his field indicates the source of the information
f
ield is optional and is displayed only when the output destination
Co
ntext
T
his field provides the content of the system information.
Information Center Configuration
Inform
ation Center Configuration Task List
Com
plete the following tasks to configure information cente
Configuring Synchronous Information Output
Configuring to Display the Time Stamp with the UTC Time Zone
Setting to Output System Information to the Console
Setting to Output System Information to a Monitor Terminal
Setting to Output System Information to a Log Host
Setting to Output System Information to the Trap Buffer
Setting to Output System Information to the Log Buffer
Setting to Output System Information to the SNMP NMS
Config
uring Synchron
S
ynchronous informati
debugging information is output when the user is inputting commands, the command line prompt (in
c
ommand editing mode a prompt, or a [Y/N] string in interaction mode) and the input information are
echoed afte
r the output.
This featur is used in the case that your input is interrupted by a large amount of system output. With
e
this
feature enabled, the system echoes your previous input and you can continue your operations from
whe
re you were stopped.
Foll
ow these
steps to configure synchronous information output:
To do...
En
ter system view
Enable synchronous
information output
Task
ous Inform
ation Outpu
on output re
fers to the feature that if the
Use the command...
system
-view
info-center synchronous
, such as the source IP address of the log sender. This
is the log host.
r:
t
system
59-7
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
information such as
log, trap, or
Remarks
—
Required
Disabled by default