3Com 4500 PWR 26-Port Configuration Manual page 76

Figure 2-11 Diagram for establishing connection to a console port
Launch a terminal emulation utility (such as Terminal in Windows 3.X or HyperTerminal in
Windows 95/Windows 98/Windows NT/Windows 2000/Windows XP) on the PC terminal, with the
baud rate set to 19,200 bps, data bits set to 8, parity check set to none, and flow control set to none.
Turn on the switch and press Enter as prompted. The prompt appears.
Perform the following operations in the terminal window to assign IP address 202.38.160.92/24 to
VLAN-interface 1 of the switch.
<Sysname> system-view
[Sysname] interface Vlan-interface 1
[Sysname-Vlan-interface1] ip address 202.38.160.92 255.255.255.0
2) Perform Telnet-related configuration on the switch. Refer to
Authentication Mode Being
and Telnet Configuration with Authentication Mode Being Scheme
3) Connect your PC/terminal and the Switch to an Ethernet, as shown in
port through which the switch is connected to the Ethernet belongs to VLAN 1 and the route
between your PC and VLAN-interface 1 is reachable.
Figure 2-12 Network diagram for Telnet connection establishment
4) Launch Telnet on your PC, with the IP address of VLAN-interface 1 of the switch as the parameter,
as shown in Figure
Figure 2-13 Launch Telnet
5) If the password authentication mode is specified, enter the password when the Telnet window
displays "Login authentication" and prompts for login password. The CLI prompt (such as
None, Telnet Configuration with Authentication Mode Being
2-13.
2-26
Telnet Configuration with
Password,
for more.
Figure 2-12. Make sure the