Sftp Configuration; Sftp Configuration: A Switch Operating As An Sftp Server - 3Com 4500 PWR 26-Port Configuration Manual

<Sysname> boot boot-loader switch.bin
<Sysname> reboot
For information about the boot boot-loader command and how to specify the startup file for a switch,
refer to the System Maintenance and Debugging module of this manual.

SFTP Configuration

Complete the following tasks to configure SFTP:
SFTP Configuration: A Switch
Operating as an SFTP Server
SFTP Configuration: A Switch
Operating as an SFTP Client

SFTP Configuration: A Switch Operating as an SFTP Server

Enabling an SFTP server
Before enabling an SFTP server, you need to enable the SSH server function and specify the service
type of the SSH user as SFTP or all. For details, see the SSH server configuration part of SSH
Operation Manual of this manual.
Follow these steps to enable an SFTP server:
To do...
Enter system view
Enable an SFTP server
Configuring connection idle time
After the idle time is configured, if the server does not receive service requests from a client within a
specified time period, it terminates the connection with the client, thus preventing a user from occupying
the connection for a long time without performing any operation.
Follow these steps to configure connection idle time:
Task
Enabling an SFTP server
Configuring connection idle
time
Supported SFTP client
software
Basic configurations on an
SFTP client
Specifying the source interface
or source IP address for an
SFTP client
Use the command...
system-view
sftp server enable
57-14
Remarks
Required
Optional
—
—
Optional
Remarks
—
Required
Disabled by default.