Setting To Output System Information To The Trap Buffer - 3Com 4500 PWR 26-Port Configuration Manual

To do...
Enable information
output for a specified
switch in a fabric
Enable system
information output to a
log host
Configure the source
interface through which
log inform ation is sent to
the log ho st
Config ure the output
rul es of system
inf ormation
Set the forma t of the time
sta mp to be sent t
lo host g
After the switches form a fabric, you can use the
information output for the switches to make the log, debugging and tr
in the fabric synchronous. Each switch send
receive s information sent b
this way, the sw
whole fabric.
Be s ure to set the correc
address will cause an error message prompting that this address

Setting to Output System Information to the Trap Buffer

Follo w these steps to s
To do...
Enter system view
Enable the information
center
Use the command...
info-center switch-on { unit
unit-id | master | a
[ debugging | log
trapping ]*
info-center loghost
host-ip-addr [ channel
{ channel-numb
channel-name } | facility
local-number ]*
info-center loghost source
interface-type
interface-number
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity |
state state } ]*
info-center timestamp
o the loghost { date |
no-year-date | none }
y other switch
itch en sures the sync
t IP address when us
et to output system information to the trap
Use the command...
system-view
info-center enable
Optional
By default, debugging information
is enabled, and log and trap informatio
ll }
output are disabled for the master switch
ging |
in a fabric. Debugging, log
information output are all disabled for
other switches in the fabric.
Required
By default, the switch does not output
information to the log host.
er |
After you configure the switch to output
informatio
uses information channel 2 by default.
Optional
By default, no source interface is
configured, and the system
automatically selects an interface as the
source interface.
Optional
Refer to
rules of system information.
Optional
By default, the time stamp format of the
information output to the log host is date.
info-center switch-on command to enable the
s its own informatio
es at the same time to
hronization of log, debug
ing the info-center
buf
59-12
Remarks
and trap
n to the log host, the switch
Table 59-4 for the default output
ap information of each switch
n to other switche s in the fabric
update the information on itself. In
gin g and trap information in the
loghost command. A loopback IP
is invalid .
fer:
Remarks
—
Optional
Enabled by default.
output
n
and