Troubleshooting Rip Configuration; Failed To Receive Rip Updates - 3Com 4500 PWR 26-Port Configuration Manual

Switch C Vlan-int1
Vlan-int4
Configuration procedure
Only the configuration related to RIP is listed below. Before the following configuration, make sure the
Ethernet link layer works normally and the IP addresses of VLAN interfaces are configured correctly.
1) Configure Switch A:
# Configure RIP.
<SwitchA> system-view
[SwitchA] rip
[SwitchA-rip] network 110.11.2.0
[SwitchA-rip] network 155.10.1.0
2) Configure Switch B:
# Configure RIP.
<SwitchB> system-view
[SwitchB] rip
[SwitchB-rip] network 196.38.165.0
[SwitchB-rip] network 110.11.2.0
3) Configure Switch C:
# Configure RIP.
<SwitchC> system-view
[SwitchC] rip
[SwitchC-rip] network 117.102.0.0
[SwitchC-rip] network 110.11.2.0

Troubleshooting RIP Configuration

Failed to Receive RIP Updates

Symptom
The Ethernet switch cannot receive any RIP update when the physical connection between the switch
and the peer routing device is normal.
Solution
Check that:
RIP is enabled by using the network command on the corresponding interface.
The interface is allowed to receive or send RIP packets.
The interface receives RIP packets in the way the peer device sends them, for example, in the
broadcast or multicast mode.
110.11.2.3/24
117.102.0.1/16
23-11