Logging In Through Nms; Connection Establishment Using Nms - 3Com 4500 PWR 26-Port Configuration Manual

Logging In Through NMS

Go to these sections for information you are interested in:
Introduction

Connection Establishment Using NMS

Introduction
You can also log in to a switch through a network management station (NMS), and then configure and
manage the switch through the agent module on the switch. Simple network management protocol
(SNMP) is applied between the NMS and the agent. Refer to the SNMP-RMON part for related
information.
To log in to a switch through an NMS, you need to perform related configuration on both the NMS and
the switch.
Table 2-11 Requirements for logging in to a switch through an NMS
Item
Switch
NMS
Connection Establishment Using NMS
Figure 2-23 Network diagram for logging in through an NMS
Configuring Source IP Address for Telnet Service Packets
Go to these sections for information you are interested in:
Overview
Configuring Source IP Address for Telnet Service Packets
Displaying Source IP Address Configuration
The IP address of the VLAN interface of the switch is configured. The route between
the NMS and the switch is reachable. (Refer to the IP Address Configuration – IP
Performance Configuration and Routing Protocol parts for related information.)
The basic SNMP functions are configured. (Refer to the SNMP-RMON part for
related information.)
The NMS is properly configured. (Refer to the user manual of your NMS for related
information.)
Requirement
2-35