Network Management Interface Configuration Example - 3Com 4500 PWR 26-Port Configuration Manual

After completing the above configuration, you can execute the cluster
{ member-number | mac-address H-H-H | sysname member-sysname } command on the
management device to switch to member device view to maintain and manage a member device.
After that, you can execute the cluster switch-to administrator command to return to
management device view.
In addition, you can execute the reboot member { member-number | mac-address H-H-H }
[ eraseflash ] command on the management device to reboot a member device. For detailed
information about these operations, refer to the preceding description in this chapter.
After the above configuration, you can receive logs and SNMP trap messages of all cluster
members on the NMS.

Network Management Interface Configuration Example

Network requirements
Configure VLAN-interface 2 as the network management interface of the switch;
Configure VLAN 3 as the management VLAN;
The IP address of the FTP server is 192.168.4.3;
Switch A operates as the management switch;
Switch B and Switch C are member switches.
Table 48-2 Connection information of the management switch
VLAN
VLAN 3 (connected to Switch
B)
VLAN 2 (connected to FTP
server)
Network diagram
Figure 48-5 Network diagram for network management interface configuration
Configuration procedure
# Enter system view and configure VLAN 3 as the management VLAN.
<Sysname> system-view
IP address
192.168.5.30/24
192.168.4.22/24
48-27
switch-to
Connection port
Ethernet 1/0/1
Ethernet 1/0/2