3Com 4500 PWR 26-Port Configuration Manual page 750

If the system information is output before you input any informati
line prompt, the system does ot echo any command line
output.
In the interaction
system output, n
input will be displ
Configuring to Display the Time Stamp with the UTC Time
T o add UTC time zone to the time amp in the information center
Set the local time zone
Set the time stamp format in the output destination of the information center to date
Configure to add the UTC time zone to the output information
Follow these steps to configure to display time stamp with the
To do...
Set the time zone for the system
Enter system view
Set the time stamp
format in the output
destination of the
information center
to date
Set to display the UTC time zone
in the output information of the
information center
Setting to Output System
Se tting to output syste
F ollow these steps to
To do...
Enter system view
Enable the
information center
n
mode, you are prompted for som
o system pr om pt (except the Y/N string)
a yed in a n ew line.
st
Use the command...
clock timezone zone-name
{ add | minus } time
system-view
Log ho st
info-center ti
dir ection loghost d
Non log
info-center timestamp { l
ho st
| trap | debugging }
dir ection
info-center timestamp ut
Informa tion to the Console
m information to the console
set to output system information to the c nsole:
Use the command...
system-view
info-center enable
on followin
pro mpt after the system information
e information inpu
will be echoed after the output, but your
Zone
ou tput information, you must:
UTC time zone:
R
By default, UTC time zone is set
for the system.
—
mestamp
ate
Required
Use
og
date
Required
By d
c
displayed in the output
information
o
—
Optional
Enabled by default.
59-8
g the current command
t. If the input is interrupted by
Remarks
equired
either command
efault, no UTC time zone is
Remarks