3Com 4500 PWR 26-Port Configuration Manual page 807

If this parameter is set to a number greater than 1, the system sends the second test packet once it
receives a response to the first one, or when the test timer times out if it receives no response after
sen ing the first one, and so d
the –n keyword in the ping command.
4) Automatic test interval
This parameter is used to enable the system to automatically perform the same test at regular intervals.
5) Test timeout time
Test timeout time is the duration while the system waits for an ECHO-RESPONSE packet after it sends
out an ECHO-REQUEST packet. If no ECHO-RESPONSE packet is received within this duration, this
test is considered a failure. This parame
different unit (the -t keyword in the ping command is in milliseconds, while the timeout time in the
remote-ping command is
Conf iguring remote-ping
Table 67-1 Configure re
Operation
Enter system view
Enable remote-ping Client
Create a remote-ping test
group
Configure the test type
Configure the destination IP
address of the test
Configure the number of
packets to be sent in each test.
Configure the automatic test
interval.
Configure the timeout time of
the test.
Execute the test
forth until the last test packet is sent out. This parameter is equivalent to
ter is similar to the -t keyword in the ping command, but has a
in seconds).
mote-ping
Command
system-view
remote-ping-agen
rem ote-ping
administrator-name operation-
tag
test-type type
destination-ip ip-address
count times
frequency interval
timeout time
test-enable
67-2
—
Required
t enable
By default,
is disabled.
Required
By defaul
group is configured.
Optiona l
By default,
ICMP.
Required
By defaul
address is configured.
Optional
By default, th
packets to
is 1.
Optional
By default, the automati
interval is ze
automatic
performed.
Optional
By default,
seconds.
Required
Description
remote-ping Client
t, no remote-ping test
the test type is
t, no destination IP
e number of
be sent in each test
c test
ro, indicating no
test will be
the timeout time is 3