3Com 4500 PWR 26-Port Configuration Manual page 767

Figure 60-4 Send file dialog box
Step 8: Click <Send>. The system displays the page, as shown in
Figure 60-5 Sending file page
Step 9: After the sending process completes, the system displays the following information:
Loading ...CCCCCCCCCC done!
Step 10: Reset HyperTerminal's baudrate to 9600 bps (refer to Step 4 and 5). Then, press any key as
prompted. The system will display the following information when it completes the loading.
Bootrom updating.....................................done!
If the HyperTerminal's baudrate is not reset to 19200 bps, the system prompts "Your baudrate
should be set to 19200 bps again! Press enter key when ready".
You need not reset the HyperTerminal's baudrate and can skip the last step if you have chosen
19200 bps. In this case, the system upgrades the Boot ROM automatically and prompts "Bootrom
updating now.....................................done!".
Figure
60-6
60-5.