Cluster Configuration Examples; Basic Cluster Configuration Example - 3Com 4500 PWR 26-Port Configuration Manual

Cluster Configuration Examples

Basic Cluster Configuration Example

Network requirements
Three switches compose a cluster, where:
A Switch 4500 series switch serves as the management device.
The rest are member devices.
Serving as the management device, the Switch 4500 switch manages the two member devices. The
configuration for the cluster is as follows:
The two member devices connect to the management device through Ethernet 1/0/2 and Ethernet
1/0/3.
The management device connects to the Internet through Ethernet 1/0/1.
Ethernet 1/0/1 belongs to VLAN 2, whose interface IP address is 163.172.55.1.
All the devices in the cluster share the same FTP server and TFTP server.
The FTP server and TFTP server use the same IP address: 63.172.55.1.
The NMS and logging host use the same IP address: 69.172.55.4.
Network diagram
Figure 48-4 Network diagram for HGMP cluster configuration
Configuration procedure
1) Configure the member devices (taking one member as an example)
# Enable NDP globally and on Ethernet 1/0/1.
<Sysname> system-view
[Sysname] ndp enable
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] ndp enable
[Sysname-Ethernet1/0/1] quit
# Enable NTDP globally and on Ethernet 1/0/1.
[Sysname] ntdp enable
48-24