Logging N And; Turning On The System - 3Com NETBuilder SI Using Manual

5
Turning on the
System
L
OGGING
A
DMINISTRATIVE
This chapter describes how to start up the system, log on, use the user
interface, and perform basic administrative tasks that you must complete
before configuring the ports and paths and bridging or routing protocols
that you plan to run on your bridge/router.
Table 9 summarizes the administrative tasks described in this chapter and
indicates whether performing each task is required, recommended, or
optional.
Table 9 Administrative Task Summary
Task
Changing the Root Password
Changing the Default Console Port Baud
Rate
Adding User Accounts
Setting the Time and Date
Setting System Information
Setting Up Security
For more information on each of the commands and parameters used in
this section, see Reference for Enterprise OS Software.
To start up your bridge/router, plug one end of the power cord into the
rear panel of the bridge/router and the other end into your power outlet.
In addition, if you have a SuperStack II Redundant Power System (RPS),
attach one end of the RPS cable to the rear panel of the bridge/router and
the other end to the RPS.
O P
N AND
T
ASKS
Status of Task
Required
Do only if you want to attach a terminal
with a baud rate other than 9600.
Optional
Recommended
Required
Recommended
ERFORMING