Section 2 Special Tools, Instruments & Meters; (I) Special Tools - ATV 250 Service Manual

Section 2 Special tools, instruments and meters

(I) Special tools

Special tools is the necessary tools used for accurately adjustment and assembly, it is
helpful to prevent the maintenance defects and components damage caused by using improper
tools.
1.Wrench for valve adjustment mainly used for adjusting valve clearance. Specification:
3mm 90890-01311
2.Puller for piston pin, mainly used of removing pistion pin.
3.Remover for rotator, mainly used for pulling magneto rotator form crank.
4. Clamp for rotator, mainly used for clamping magneto rotator when removing it to pre-
vent it's rotation due to torque force.
5.Stop rotating meter for rotator, mainly used for removing and assembling rotator of kick
starter.
6.Puller for crank, mainly used for disassembling crank from crankcase.
7.Puller for rocker shaft, mainly used for removing rocker shaft.
8.Compressing tools for spring of valve, mainly used for fixing and compressing spring
when assembling valve lock clamp.
9. Assembling and disassembling tool for valve guide, mainly used for assembling and
disassembling valve guide.
10.Assembling buffer, mainly used for assembling crank and balancing gear.
11.Hollow sleeve, mainly used for assembling crank and balancing gear.
12.Assembling toal for crank, mainly used for assembling crank and balancing gear.
13.Assembling and disassembling joint for universal coupling, mainly used for assembling
and dismsembling universal coupling.
14.Assembling and disassembling disc, mainly used for assembling and disassembling re-
verse gear.
15.Fixed puller for gear, mainly used for assembling and disassembling gear.
For the above tools, you can select with reference to special tools of the same type
of vehicle.
-2-