(V)Installation Steps Of Steering Bar - ATV 250 Service Manual

(V)Installation steps of steering bar

1.Install the lower holding seat¢Ù , steering tube
¢Ú and upper holding seat ¢Û .
Warning
When tightening the bolt of holding seat, make
ensure the even of clearance .
Attached:bolt torque:20Nm
2.Install the throttle grip unit
Caution
The projection ¢Ùof throttle grip must corre-
spond to the sunken part ¢Úon the right lever
seat when installation.
Warning
Correct installation of cable and wire is very
necessary for ensuring the safty operation of
vehicle.
Refer to chapter 1"wiring diagram of vehicle"
3.Ajusting the free clearance of brake cable
Refer to "Adjustment of Front brake"and "Ad-
justment of free clearance about left handle
lever and rear brake pedal "in chapter2.
4.Adjusting the toe-in of front wheel
Refer to "Adjustment of Front twheel Toe-in"in
chapter2.
5.Mounting front fedner, bumper, front luggage
carrier.
Refer to the second section of chapter2.
-100-