Section 6 Wiring Diagram Of Atv; (I) Technical Explanation And Requirement, Details Of Relative Component - ATV 250 Service Manual

(I)Thechnical explanation and requirement, details of relative compenent.
1.Technical explanation
A Main switch wire, indicator wire, mile-
age meter wire (mounting digital mileage meter)
must be put throught the guide grip of holding
seat of steering bar. (see fig.1)
B Rear brake vent-pipe, carburetor vent-
pipe and vent-pipe of rear driving gearbox must
be inserted into the hole of supporting pad of
vent-pipe.(see fig.1, also see view D)
C Neutral and reverse switch wire, mile-
age meter wire(mounting with digital mileage
meter) should be fixed with bands here.(see
fig.1)
D After putting overflowing pipe of car-
buretor through two rear fixing part of engine
(on thge frame), then put it in the proper posi-
tion between engine and rear arm. Note: Over-
flowing pipe be unblocked.(see fig.1)
S After putting rear brake cable, throttle
cable, wire of starting motor and mileage meter
(mounting with digital mileage meter )through
wire hook2, wire hook 2should be bent accord-
ing to the method of view A.
P In this position, starting motor wire and
mileage meter wire(mounting with digital mile-
age meter)must be put throughh the hole of plas-
tic grip in the fuel tank support of frame..(see
view B-B)
R In here, rear brake cable, rear brake
vent-pipe and mileage wire(mountig with digital
mileage meter)must be first put through wire
hook 2, then connect with respective matching
unit.(see fig. B-B)
Q In here, wire of reverse switch neutral
switch, and mileage meter (mounting with digi-
tal mileage meter)must be fixed with bands.(see
fig.B-B)
-16-

Section 6 Wiring diagram of ATV

T When assembling the wire of ser. No.
14 and No.15.don't need to put through the guide
clip of holdig seat of steering bar.(see fig.E-E)
W After putting the vent-pipe of tank
through the hole of main switch, lead it to the
lower of right side of steering bar, then put it
through the wire hook on the frame.
Note: Hose must be unblocked.(see fig.
E-E)
V The leading wire on the switch units of
steering bar, must be bound with band,(see fig.
G-G)
E After the vent-pipe of front brake is put
through plastic clip hole on the frame, surplus
portion should be put in the proper position of
frame.(see fig.2)
G After the vent-pipe of battery is checked
and no twist is found here, then insert it in the
presetting hole of rear fedner.(If free of mainte-
nance battery is used, then this item of require-
ment doesn't need.)(see fig.3)
H Wire of rear brake cable, rear brake
vent-pipe and mileage meter(mounting with digi-
tal mileage meter)should be put through the cable
frame welded on the frame in here.(see fig.3)
F In here, wire of starting motor must
be first put through the plastic clip on the
frame, then connect with the matching units.
(see fig.3)
L Vent-pipe of battery should be put
through the plastic clip fixed on the frame.(see
fig..)(If free of maintenance battery is used, then
this item of requirement doesn't need.)
K In here, wire of throttle cable, rear brake
cable and mileage meter(mounting with digital
mileage meter )should be put through the cable
guide frame welded on the frame.(Throttel cable