(Iii)Inspection Content - ATV 250 Service Manual

(III)Inspection content

1.Check if the steering bar is cracks bent, is
bent or damaged. If it is, replace it.
2.Inspect if the steering vertical column weld-
ing assy is bent or damaged. if it is, replace it
Warning
In order to avoid decreasing the performance
of steering vertical column, if it is bent do not
straighten it frocefully.
3.Inspection
Steering vertical column holder¢Ùand seal ring
¢ Ù ¢ Ú .If they are worn or damaged, replace it.
4.Inspection:
If the tension rod ¢Ùis bent or damaged. If
they are, replace them.
5.Correcting:
The displacement of end head of steering ten-
sion rod ball pin assy(Refer to as pin ballas
shown on the drawing).If the free clearance
is found on the ball pin end head ,replace the
ball pin. If the part around the ball pin end head
is uneven, also replace it.
If there is convex point, wear, damage on the
core surface of ballpin end head, replace it.
-96-