(I)Removal Steps - ATV 250 Service Manual

(I)Removal steps

1.Rest the motorcycle on a flat ground.Press
the rear brake clip ¢Ù .
2.Loosen the connecting nuts of front and rear
wheels.
3.Stop up the front wheel with wood, then put
a proper supporting article under the frame so
as to lift the rear wheel and make the rear
wheel leave the earth.
¢Ù
In order to avoid the parts falling, which will
cause danger, during romoval process, rest
the vehcile firmly.
4.Removal (the Ser. No is corresponding to
the Ser.No on the drawing)
¢Ùconnecting nut of front and rear wheels
¢ÚLeft rear wheel
¢Û Split pin
¢ÜRear wheel axle nut
¢ÝWasher
¢ÞRear wheel connecting plate
5.Removal (the Ser.No is corresponding to the
Ser. No on the drawing)
¢ÙConnecting nut of front and rear wheels
¢ÚRight rear wheel
¢Û Split pin
¢ÜRear wheel axle nut
¢ÝWasher
6.Loosen the rear brake clip
7.Removal:
Brake shoe assy ¢Ù
-85-