(Iii) Mounting - ATV 250 Service Manual

Take off bearing ¢Û with usually bearing tool
The reverse step of "bearig and oil sealing re-
placing step"is the mounting step of new bear-
ing and new oil sealing.
Caution
Use a pressure tooling ¢Ü which is match with
outer diameter of bearing race ¢ß and oil
sealing.
Warning
Don't strike the bearing inner race ¢Ý and
roller.
The pressure tooling ¢Ü is only contact with
outer race ¢ß .
(III)Mounting steps:
The reverse steps of "disassembly is the mount-
ing step,but the following points must be paid
attention during the installation: "
1.Lubricate the bearing ¢Ù , oil sealing ¢Ú ,bush
¢Û and rear arm joint bolt ¢Ü .
Lubrication oil is Lithium base grease.
2.Mount the real wheel fork assy, rear wheel
fork bushing and rear arm joint bolt.
-111-