ATV 250 Service Manual page 99

15.Installment
split pin4 ¡Á30 ¢Ù
Caution
After fastening the forque, the nut on the rear
wheel axle is not allowed to be loose. If the nut
concave groove is not align with the splint hole
on the screw rod, make it by tightening up the
nut.
Warning
Always use the new split pin
16.Installment
Right rear wheel ¢Ù
Connecting nut of front and rear wheels ¢Ú
Attached:The torque of the connectinig nut of
front and rear wheels is 55Nm.
Caution
The rotating direction of the wheel is the arrow
marking direction on the tire. For this, refer to
"Front wheel and front brake"section of this
chapter.
Warning
When installing the core nut to the rear wheel,
be sure to face its core edge to the wheel.
18.Installment
connecting plate of rear wheel ¢Ù
Wasehr 16 ¢Ú
Rear wheel axle nut M16 ¢Û
Split pin4 ¡Á30 ¢Ü
Left rear wheel ¢Ý
Connecting nut of front andrear wheels ¢Þ
Refer to "Rear wheel"section of this chapter.
19.Adjustment
Rear brake pedal clearance
Rear brake cable clearance
Refer to "Adjustment of left lever and rear brake
pedal free clearance "Section of chapter Two.
Attached:
Rear brake pedal clearance:20-30mm
Clearance of left lever centre:5.0-8.0mm
-93-