(Iii)Installment Steps - ATV 250 Service Manual

(III)Installment steps:

The reversal steps of "removal steps",that is
installment steps.Pay attention to the follow-
ing points when installing:
1.Lubrication part
¢ÙOil seal lip of rear wheel axle.
¢ÚBearing of rear wheel axle.
The corresponding spline tooth of rear wheel
axle.
The lubrication oil is lithium base grease.
2.Installment
Installment of rear wheel axle ¢Ù
Caution
Before installing the rear wheel axle, loosen
all bolts on the driving gear case ;hole the rear
wheel axle with hand to make it enter the rgear
groove of gear case, apply on the left end of
the axle slightly with soft hummer.
Warning
In order to protect the axle thread and spline
tooth of axle, never beat the end face of axle
directly with hummer.
3.Installment
Plain pad of rear brake cover
O-ring 30 ¡Á1.8G
4.Labrication of rear brake cam shaft.
The lubrication oil is lithium base grease.
-90-