ATV 250 Service Manual page 220

-214-
3. Mount:
¡¤ Drive assy of rear wheel and rear wheel fork
Assembly steps:
1) Lubricate following parts before mounting
the rear wheel fork
¡¤ Bearing ¢Ù
¡¤ Oil sealing ¢Ú
¡¤ Bushing ¢Û
¡¤ Coupling bolt of rear arm ¢Ü
¡¤ Spling of drive shaft ¢Ý
Spline of main drive gear¢Þ
Lubrication oil:
Lithium base lubrication oil
2) Mount the drive shaft ¢ßon the spline ¢Þof
main drive gear.
3) Pull rear wheel fork forward, and mount
drive shaft ¢ß on the rear joint of direction knot
¢à .
4. Connect:
Rubber bushing etc ¢Ù .
5. Mount:
¡¤ Coupling bolt ¢Úof rear arm
¡¤ Rear arm nut ¢Û
¡¤ Coupling bolt ¢Üof rear arm
Caution
Turn the rear arm shaft bolt and rear arm shaft
nut temporaly, and don't fasten them at this time.
6. Check:
¡¤ Operation of drive shaft
Checking steps:
¡¤ Hold the front wheel and put the proper
bracket on the fram for lifting rear wheel
¡¤ Front and rear turning rear wheel
¡¤ Front and rear turning rear wheel
Check the operation of driving shaft. If the op-
eration is not good, check the installation of drive
shaft again.