ATV 250 Service Manual page 150

8.Rear driving unit and rocker(rear wheel fork
and shock absorber)
1)Remvoe
.Remvoe the air ¢Ù(air case of last grade and
rear brake hub)from the clip on the frame.
.Fix the front wheel and raise up the rear wheel
(place the supporter on the frame)
2)Remove
.Bolt ¢Ù (upper end of the rear shock absorber)
3)Remove
.Hoop ¢Ù(rubber hood)
.Dustproof cap of rear arm shaft ¢Ú
.Rear arm nut ¢Û(right)
.Connecting screw column of rear arm ¢Ü
(right)
Connecting bolt of rear arm ¢Ý (left)
4)Remove
.Rear wheel driving unit /rocket assy
Caution:
.When disassembling the rocker assy, support
the shock absrober to avoid droping down.
.When removing the rocker from the rubber
hood, the driving shaft may drop down,Pay
attention not to lose components.
9.Disassembly of engine
1)Remove
.Bolt¢Ù (top supporting of engine)
.Bolt ¢Ú (bottom supporing of engine)
.Bolt¢Û(rear upper supporting of engine)
.Bolt¢Ü(rear lower supporting of engine)
2)Remove the engine unit from right side
-144-