ATV 250 Service Manual page 161

¢Ú
¢Ü
¢Ù
¢Û
¢Ü
¢Û
¢Ý
¢Ù
¢Þ
¢Ú
¢Ù
¢Ý
¢Þ
42.Remove
.Rocker shaft ¢Ù
.Air intake and exhaust rocker ¢Ú
Caution
.Screw the slip hammer assy into rocker shaft,
then pull out the rocker.
43.Remove
.Valve lock clip¢Ù
Caution
.Disassemble the valve lock clip with valve
spring compressing device.
44.Remove
.Valve spring cover ¢Ù
.Valve outer spring ¢Ú
.Valve inner spring ¢Û
.Valve ¢Ü
.Oil seal of valve rod ¢Ý
.Spring seat of valve ¢Þ
Caution
.Pay attention to position of each component
for installation to original position.
45.Remove
.Starting lever cap ¢Ù
.Starting lever ¢Ú
Caution
.Before uniting the knot ¢Û ,pull out the rope
long enough to tie a knot to avoid to be pulled
into the cap
46.Remove
.Screw pin ¢Ù
.Guide plate ¢Ú
.Compressing spring¢Û
.Circlip¢Ü
.Driving jaw ¢Ý
.Torsion spring¢Þ
-155-