ATV 250 Service Manual page 188

-182-
4)Inspection
.Reverse fork ¢Ù
If wear/abrasion/bend/damage is found on the
surface connecting with connecting jaw and re-
verse operating shaft,replace it.
.Compressing spring¢Ú
If the elasticity is lost,or worn replace it
.Steel ball ¢Û
If wear,damage,or scratch marks is found,re-
place it
5)Inspection:
Reverse fork shaft
Roll the reverse fork shaft on the flat surface,
if bent,replace it.
Caution
Never straighten a bent shaft and reuse it
6)Inspection
.Flexibility of fork movement
Install the reverse fork ¢Ù to forkshaft,if not
active or smooth in operation,replace fork and
fork shaft.
7)Inspection
.Reverse control lever ¢Ù
.Operating plate ¢Ú
.Reverse operating shaft ¢Û
If bend,cracks or damage is found, replace it.
8)Inspection
.Rear cover ¢Ù
If cracks or damage on the position connecting
with left crankcase,rear driving cover is found,
replace the rear cover.
.O-ring ¢Ú
If damaged or deformed,replace it
Caution
When replacing the rear cover,be sure to re-
adjust the gear core washer,refer to"Selection
of Adjusting washer"sectsion.