ATV 250 Service Manual page 159

¢Ú
¢Û
¢ß
¢Ú
¢Û ¢Ý
¢Þ
34.Remove
.Locking washer ¢Ù
¢Ù
.Balance shaft gear ¢Ú
.Flat key ¢Û
35.Remove
.All the closing case screw.
Caution
Loosen every screw1/4 circle with cross-slot
screwdriver, then remove all of them
36.Remove
.Left crankcase ¢Ù
.Location pin ¢Ú
Caution
.Disassemble the left crank case with crank-
case separator.
.Tighten up the screw of separator, and must
keep th separator body parallel with crank-
case face. If necessary, screw the screw in
reverse direction to adjust the separator body
level.
.When appling force to case body separator,
knock the front supportor of engine, shift shaft
and balance shaft alternatly and continuely.
37.Remove
.Long fork shaft ¢Ù
.Short fork shaft ¢Ú
¢Ù
.Shift cam shaft ¢Û
¢Ü
.Fork 3 ¢Ü
.Fork 2 ¢Ý
.Fork 1 ¢Þ
Caution
Pay attention to position of every part, espe-
cially the position and direction of every fork.
-153-