(Iv) Position Adjustmen Of Steering Lever; (V) Lubricating Oil Level Inspection Of Rear Driving Gearcase - ATV 250 Service Manual

(IV)Position adjustment of steering lever
.Position adjusting procedure of steering lever.
.Place the vehicle on the flat guound.
.Change the shift to the 1st gear, and pull the
steering lever ¢Ùto reverse gear position.
.Loosen the locking nut ¢Ú
.Screw in or out the adjusting nut ¢Ûof steer-
ing lever until the middle line of the tension
rod plate aims at the alignment mark on the
rear transmission cover (or the vehicle will not
release the gear in driving when on driving or
reverse gear.)
.Screw tightly lock nut ¢Ú
Torsion of lock nut :15N.m
Caution
After adjusting the steering lever, ensure the
reverse gear indicator to light up when the steer-
ing lever is on reverse gear position.
(V)Lubricating oil level inspection of rear driv-
ing gear case.
Check the lubricating oil level of rear driving
gear case. Refill the oil if the level is low:
Caution
The engine must be in cold state. (at normal
temperature.)
Checking procedure:
.Place the vehicle on the flat ground.
.Place an oil catcher under the rear driving gear
case.
.Remove the oil filling screw plug ¢Ùand seal-
ing washer.
.Observe the oil level: the correct lever should
be on the bottom of oil filling hole.
.If the oil level is too low, please refill the rec-
ommended engine oil to specified oil level.
Refer to the section "Replacement of engine oil
of real driving gear case".
.Check the damage of sealing washer .If
damaged, replace it .
.Install the sealing washer and oil filling screw
plug ¢Ù.
Caution
.Install the sealing washer firstly before install-
ing the oil filling screw plug.
.After installing the oil filling screw plug, check
the leakage.
Torsion of oil filling screw plug: 23N.m
-42-