ATV 250 Service Manual page 199

¢Û
¢Ü
¢Û
50Nm
¢Ù
¢Ú
2. Output shaft assy
1) Mount
¡¤ Bearing ¢Ù (to rear cover)
¡¤ Nut collar ¢Ú
¢Ù
Caution
¢Ú
Use the nut collar spanner ¢Û to tighten the collar.
3) Mount
Washer ¢Ù
¡¤ Reverse gear ¢Ú
¢Ú
¢Ù
¡¤ Compromise left-turning nut ¢Û
Caution
¡¤ Fasten the compromise left-turning nut by
counter clockwise direction, because it is left-
turning thread.
¡¤ Use special-shaped nut spanner ¢Ü
4) Fasten
¡¤ Special-shaped left-handed nut
5) Mount:
¡¤ Washer ¢Ù
¡¤ Bearing ¢Ú
¡¤ Nut collar ¢Û
¢Û
Caution
¢Ü
¡¤ Use allen wrench ¢Ü
¡¤ Coat¡°518 anaerobic sealing gum¡± or equal
substitute on outer end surface of bearing ¢Ú
which side is near to washer.
¡¤ Coat thread fastening agent on allen nut collar
¢Û
6) Fasten
¡¤ Allen nut colar
-193-