ATV 250 Service Manual page 187

30.Hand operated mechanism
1)Inspection
.Inspection ¢Ù
If cracks beat,damaged,replace it.
.Driving jaw¢Ú
.Compressing spring¢Û
.Torsion spring¢Ü(Driving jaw position)
Wear/cracks/damage,replace it.
2)Inspection:
.Rolling spring¢Ù (Starting)
Wear/cracks/damage,replace it.
.Tension wire ¢Ú
Wear/cracks/damage,replace it.
.Driving plate assy ¢Û
Cracks/damage,replace it.
31.Output mechanism
1)Inspection
.All gears ¢Ù
If pressing mark/abrasion/wear is foud,replace
it
.Connecting jaw ¢Ú
If pressing mark/abrasion/wear is foud,replace
it
.Driving shaft ¢Û
.Output shaft ¢Ü
If damaged or bent,replace it.
Caution
When replace arry gear or output shaft,be sure
to readjust core gear washer,refer to¡± Se-
lection of adjusting washer¡± section.
2)Inspection
.Bearing ¢Ý
If pressing mark or abrasion is found,replace
it.
3)Inspection
.Front joint and rear join¢Ù
.Driving fork¢Ú
.Needle bearing ¢Û
-181-